Setup
Overview
How to broadcast over
the Internet (WebClient and MultiClient)
Network
Overview
1)
Modem: For Dial-up connections, Modify Image Quality and Image
Precision.
2)
Broadcast Status: To start the web server, click WebStart. To stop, click WebEnd.
You may be prompted for Windows
Firewall security alert, click Unblock to allow connection.
3)
Make Client Install Diskettes: Insert floppy into A: drive and click Copy
to load MultiClient software to diskette.
4)
Lan: For Ethernet connections. Modify Image Quality and Image Precision.
5)
To enable DHCP, check box and click Apply. It will require the system to reboot.
6)
To manually enter network information, uncheck DHCP and
type in information then click Apply.
How to broadcast over the
Internet (WebClient and MultiClient)
1)
Check that the Internet is connected and running.
2)
If system is connected to a router, port forward 9123,
80 and 8080. Refer
to the router manufacturer’s manual for directions on port forwarding.
3)
Go to Control Panel, Windows Firewall,
and Exceptions. Check LDWebserver,
click OK. (Note: To exit DVR System without turning off
computer, press Shift while clicking Power button)
4)
Turn on web server by clicking WebStart in Network
Setup. Click Unblock if
prompted.
5)
Uncheck Enable DHCP and enter Static IP Address,
Subnet Mask, Gateway, Default DNS Server,
and Sub DNS Server. Consult
your Internet provider for details.
6)
Click Apply.
Click OK to restart computer.